Please note as of Wednesday, August 15th, 2018 this wiki has been set to read only. If you are a TI Employee and require Edit ability please contact x0211426 from the company directory.

Talk:Setting up OMAP-L137 Target File System

From Texas Instruments Wiki
Jump to: navigation, search
For technical support please post your questions at http://e2e.ti.com. Please post only comments about the article Setting up OMAP-L137 Target File System here.

Comments on Setting up OMAP-L137 Target File System


Mtzgustavo said ...

Might want to comment that if running "/sbin/ifconfig" on a Vmware Linux image returns a loop back IP address (127.0.0.1), then you will have to reconfigure your network setup.

--Mtzgustavo 16:24, 7 April 2009 (UTC)

Jpplus said ...

when run host $ arm_v5t_le-gcc hello.c -o hello seems cannot find the "stdio.h", how to include these stdio.h /stdlib.h/socket.h in search path? where these header file are?

--Jpplus 04:24, 7 September 2009 (CDT)

Michele sponchiado said ...

In my case: 1-I was working with a switch between host and target board, so I've configured serverip, ipaddr and nfshost env variables to correct values 2-Montavista asks for password at the end of boot; the only way to get it work was to follo the instructions in http://linux.davincidsp.com/pipermail/davinci-linux-open-source/2008-November/009329.html

--Michele sponchiado 04:07, 11 January 2010 (CST)

Robert.Krejci said ...

If this: EVM # setenv bootcmd 'dhcp;bootm' does not run, try: EVM # setenv bootcmd 'tftp;bootm'

--Robert.Krejci 11:21, 15 January 2010 (CST)

There are no threads on this page yet.